50 vendidos
$150.908
+ impuestos: $31.691
220 opiniones
Amber S.
I made my cnc plasma cutter using this setup with just a little bit of research on YouTube on how to set it all up. Works with both my old laptop and my raspberry pi as the controller
Bahadir Balban
Bought July 2024. I was careful to do the set up correctly:1. Upload grbl to arduino was OK2. Connected heat sinks to drives making sure there are no shorts.3. Connected drives to the CNC board making sure EN corner matches the same corner on CNC board.4. Connected the motors. Never power on with drives without motors.5. Add the GND - EN jumper on the CNC board.6. Power on with a PSU of 30V and 10A with correct polarity.7. Install the universal grbl program and send commands.Troubleshooting: ...
Falling Entropy
Great kit. Relatively easy to implement into my 3D-printer project.
R. gerra
So let's start with the bad:1. There is a bit of a misleading description. The packaging contents clearly state that there are six limit switches, but only three come with the unit. The seller has stated that it can be interpreted either way, but I dont see it. To overcome this, buy additional switches. They're cheap. Seriously, they're not only cheap, but they're pretty common models.Suggestion: they're cheap, so the seller should clear this up once and for all and just change the product so...
Peter Lynch
I am a novice with adruino however in fairness I work with plcs and high end motion control so I have a basic understanding of what would be needed to get a motor to function.When you get the kit it has the uno board, the stepper drivers from Texas instruments with heat sinks, as well as the cnc shield controller and zero instructions....So my guess is this kit is aimed at the hobbyist or kids with little experience and if that's the case you need to watch several videos as boring as that sou...
Tu pregunta fue enviada. Te responderemos pronto.
· Recibirás la respuesta a
BIGTREETECH Direct
